[AudioI] read error

[Matt Flax]

It looks like it should work.

The fact that ALSA/Linux finds the card and sets it up means that you 
have got I2C working.

Perhaps there is a clocking I2S bus issue ? How long does it take before 
it reports the error ?

Matt

On 12/7/22 15:34, mark via People wrote:
> Excited to add audio to my Pi, and just finished assembling the boards.
> I see the device listed with arecord -l.
> But, when I go to capture there is a read error.  Any suggestions on 
> how to troubleshoot appreciated.
>
> pi at cam-09:~ $ sudo arecord -l
> **** List of CAPTURE Hardware Devices ****
> card 0: audioinjectorul [audioinjector-ultra], device 0: 
> bcm2835-i2s-cs4265-dai1 cs4265-dai1-0 [bcm2835-i2s-cs4265-dai1 
> cs4265-dai1-0]
>   Subdevices: 1/1
>   Subdevice #0: subdevice #0
> pi at cam-09:~ $ arecord --device="hw:0,0" -c2 -r 48000 -f S32_LE -t wav 
> -V stereo -d 30 -v file_stereo.wav
> Recording WAVE 'file_stereo.wav' : Signed 32 bit Little Endian, Rate 
> 48000 Hz, Stereo
> Hardware PCM card 0 'audioinjector-ultra' device 0 subdevice 0
> Its setup is:
>   stream       : CAPTURE
>   access       : RW_INTERLEAVED
>   format       : S32_LE
>   subformat    : STD
>   channels     : 2
>   rate         : 48000
>   exact rate   : 48000 (48000/1)
>   msbits       : 32
>   buffer_size  : 24000
>   period_size  : 6000
>   period_time  : 125000
>   tstamp_mode  : NONE
>   tstamp_type  : MONOTONIC
>   period_step  : 1
>   avail_min    : 6000
>   period_event : 0
>   start_threshold  : 1
>   stop_threshold   : 24000
>   silence_threshold: 0
>   silence_size : 0
>   boundary     : 1572864000
>   appl_ptr     : 0
>   hw_ptr       : 0
> arecord: pcm_read:2152: read error: Input/output error
> pi at cam-09:~ $
>
>
>
-- 
Checkout the community email list :
https://lists.audioinjector.net/mailman/listinfo/people