Yikes ! Mistakes happen.

Ok - it sounds like your i2c lines and that part of the codec are still working (because you still have comms with the codec).

Where did the smoke come from ?

Matt

Hello,

I just built my ultra 2. Unfortunately, I soldered on a male 40 pin adapter the wrong way (long pins on the underside of the board), and had a lot of trouble removing it to reverse it. Some pads lifted. I was able to re-solder it on the other side, and get the raspberry pi to detect the card. When I went to record using the "rec" command, I got a sinc error. No matter the value I put in, it would say it was a bad parameter for sinc. 

Even worse, I thought that this was due to having the 40 pin cable backwards on the pi, and when I reversed it, the magic smoke got let out. After putting the cable back to how it was the first time, the pi still detects the card, but just hangs. It would just say "recording" (in audacity) and do nothing. No time would advance. 

Is there any way to test the card to see how damaged it is? Thanks for your help in advance!

Larry

-- 
Our latest product launching now on Kickstarter :
https://bit.ly/2Qr1557
Checkout the community email list :
https://lists.audioinjector.net/mailman/listinfo/people